Voodoo5 6000 und Voodoo5 6000 by Anthony (Snowhite) compabilty

  • Lange nicht mehr hier gewesen, möchte aber kurz etwas beitragen.

    Im Startpost ist das Tyan Tiger S2466 mit AMD 760MPX gelistet. Soweit ich weiß ist der 760MPX ein reiner AGP 2.x Chipsatz, ergo 1.5V. Laut Datenblatt kann das Teil keine 3.3V am AGP Port bereitstellen. Das gleiche gilt für die beiden AMD 761 Boards, die sollten ebenfalls nur mit 1.5V laufen.

  • Tyan Tiger MPX S2466 hat auf jeden Fall AGP 2x mit 3,3V

    Hatte ich als erstes Board für meine 6k in Verwendung

    Dem so korrekt sein tun tut.

    Hatte ich in Verbindung meiner Voodoo 5 5500, bevor ich damals zum EPOX 8K5A2 gewechselt bin.

    "Du bist und bleibst a Mensch und du kannst eben net deine menschlichkeit überwinden."

    Dennis_50300

  • Lange nicht mehr hier gewesen, möchte aber kurz etwas beitragen.

    Im Startpost ist das Tyan Tiger S2466 mit AMD 760MPX gelistet. Soweit ich weiß ist der 760MPX ein reiner AGP 2.x Chipsatz, ergo 1.5V. Laut Datenblatt kann das Teil keine 3.3V am AGP Port bereitstellen. Das gleiche gilt für die beiden AMD 761 Boards, die sollten ebenfalls nur mit 1.5V laufen.

    Hast du evtl. AGP 2x mit AGP 2.x verwechselt? (Geschwindigkeit vs. Spezifikation)

    AGP 1.0 = AGP 1x/2x (immer 3,3V) (meistens nur sehr alte Brette bis P II, eher was für V2 System als für V3, V5)

    AGP 2.0 = AGP 4x (kann oft beides 3,3V und 1,5V)(universal AGP)(kann man quasi alles reinstopfen, in abhängigkeit mit dem Chipsatz)

    AGP 3.0 = AGP 8x (kann nur 1,5 bzw. 0,8V) (Nix Voodoo 3, 5, 6000AGP)

  • Tyan Tiger MPX S2466 hat auf jeden Fall AGP 2x mit 3,3V

    Hatte ich als erstes Board für meine 6k in Verwendung

    Sehr interessant... Ich habe derzeit ein Tiger MP (S2460) im Aufbau, da könnte ich meine V5 5500 dann mal versuchen. Oder?! Im Manual des Boards ist leider nur die AGP Geschwindigkeit (1x bis 4x) aber nicht die Spannung erwähnt. Und das Datenblatt vom AMD 762 erwähnt nur AGP 2.0 als Spec.

    Hast du evtl. AGP 2x mit AGP 2.x verwechselt? (Geschwindigkeit vs. Spezifikation)

    Nein, ich bin mir des Unterschieds sehr wohl bewusst. Mein Denkfehler war dagegen anzunehmen, dass Uinversal AGP (3.3V+1.5V) nicht für AGP 2.0 gilt ;)

  • Please add the following two AMD 760MPX mainboards to the green compatibility list:

    Iwill MPX2:

    Gigabyte 7DPXDW-P


    these both support all HiNT based Voodoo5 6000 graphics cards and they are far more reliable than anything TYAN ever created, the TYAN Tiger & Thunder 760MPX boards should be placed in the Orange list they boot but are referred as highly unreliable.

  • Update von meiner Seite:

    Die originale V56k läuft sicher mal mit einem Gigabyte GA-7DXR+ (AMD).

    Ich hatte sie auch schon auf einem Gigabyte GA-8ST667 Rev. 3.0 (Pentium 4) zum laufen gebracht.

    Die "Strange God" AGP ist hier etwas spezieller. Aktuell habe ich selbiges P4 Motherboard verbaut. Beim Aufstarten macht sich das BIOS mit folgendem Peep-Code bemerkbar "1x long, 3x short Beeps", was soviel wie "One long beep followed by three short beeps means that either the video card isn't installed or the memory on the video card is bad." heisst.

    Das 2D-Signal ist da, via Amigamerlin 3.1-R11 läuft auch schon eine 3DMark2000-Demo 640x480 durch. Mit dem vorherigen Treiber "Win2k 1.05.05" gab's schon mal Abstürze und Grafikfehler bei der Demo. Ohne Neustart lief da nichts mehr.

  • Surrimugge Kannst du mal bitte ein scharfes Bild von der Vorderseite und der Rückseite der Karte einstellen? Ich habe da eine Vermutung. Evtl. auch eine Abhilfe.

    Ich schau mal wie ich das hinbringe.
    Anscheinend ist da doch was nicht in Ordnung. Ich vermute mal eine Lötstelle. Für einen defekt im Chip sieht das zu sauber aus.


    800x600 Fastest Performance1024x768 Fastest Performance1280x1024 Fastest Performance1280x1024 2xFSAA1280x1024 4xFSAA
  • it's a d3d bug in the w2k drivers. i'm sure that the glide games won't expose it. what is your system?

    the w2k drivers have more bugs than w9x ones.

    also the most compatible system is via kt266/333. and Win2k 1.05.05 is not supporting 4-chip cards, forget about it. only 3rd-party drivers for win2k/xp are working with such cards. and again win9x drivers are much better just because 3dfx spent more time working on these.

  • it's a d3d bug in the w2k drivers. i'm sure that the glide games won't expose it. what is your system?

    the w2k drivers have more bugs than w9x ones.

    also the most compatible system is via kt266/333. and Win2k 1.05.05 is not supporting 4-chip cards, forget about it. only 3rd-party drivers for win2k/xp are working with such cards. and again win9x drivers are much better just because 3dfx spent more time working on these.

    thx for the feedback.

    Glide is looking good.


    NFS3 1600x1200 Glide

    The current system (Hadn't the time to optimize it):
    GA-8ST667 Rev. 3.0, Intel® Pentium® 4 (Northwood) 3.06GHz, 1GB DDR RAM, Creative SoundBlaster Audigy 2 ZS

    At the moment it's running with WinXP. I'm still trying to set-up the system with win98, but it seem's that's a tricky one.

  • Probier mal nen älteren SFFT, der sollte diesen Fehler nicht aufweisen. Gut sind die SFFTs bis ca. Version 46. Darüber ist oftmals muell (tm).

    "Du bist und bleibst a Mensch und du kannst eben net deine menschlichkeit überwinden."

    Dennis_50300

  • yes, as the sfft has its own d3d part it may be free from such common bugs.

    i remember that glitch on the intel platform but don't remember if it is solvable. because i've dropped using voodoo cards with winxp/2k due to a raw drivers. the only recommended platform for win2k is amd and via333 in terms of compatibility. win98 drivers have much less issues.