Ich habe hier ein Mainboard mit Edoram und SDRAM.
Dazu folgende weitere Infos.
"System memory is necessary to operate the Spitfire EX
system board. The Spitfire EX has four 3.3V unbuffered
64/72-bit, 168-pin DIMM sockets for a maximum of 1GB
of memory. Support is provided for EDO and SDRAM
memory. This section list the rules for adding memory to
the Spitfire EX, give some examples of common memory
configurations and show how to physically install the
memory.
Adding Memory
The following is a list of rules to follow when installing
DIMMs. If you follow these rules, your upgrade should be
trouble-free:
❏ Use 10ns or faster SDRAM or 60ns or faster EDO
DIMMs.
❏ DIMM memory modules support EDO and SDRAM
(unbuffered) memory types.
❏ Singled-sided and double-sided memory modules are
supported.
❏ Different memory types and sizes in separate banks
will cause the performance of the memory to run at
the speed of the slowest RAM installed and/or cause
operating system stability problems.
Four 3.3V unbuffered 64/72-bit 168-pin DIMM sockets
Maximum memory 512MB for SDRAM
Maximum memory 1GB for EDO
Supports EDO and SDRAM memory simultaneously
ECC support via chipset"
Welche Kombination wäre rein aus technischer Sicht, euer Meinung nach am sinnvollsten?
SDRAM würde ja nur bis zu 512MB gehen und Edoram bis 1GB.
Oder wäre gar ein Mix von beiden sinnvoll?
Ich würde auf dem dualen CPU System schon Spiele testen wollen die von 512MB und mehr profitieren könnten.
Supported RAM size: | 1 GB |
Supported RAM types: | SDRAM, 168-pin EDO |